Purge into waste bin, Crane Quad

I want to purge into a waste bin instead of creating a purge block and my idea was to set the purge position at Y= -10mm so the purge misses the bed. Voxelizer will accept the -10 value and will slice the model (with a warning that the model is too large), but the purge still happens at Y= -10 no problem. My printer bed will physically move beyond Y=
Please would you advise how I can get the printer to purge off the bed?

hi,

the only way i found is to set artifact type “purge” and in filament presents “purge artifact Y” to -10 and deactivate “start from infill” and “Purge artifact shield”.

But the warn message still popup, programmer should add “Extruder startgcode” like in cura(or other) so this would be much better.

Sorry for the late reply. Thank you, I got it working.

Kind regards,

Kevin