Promega Quad Layer Shifting


#1

When using voxelizer experimental, no matter what options I choose or speeds. I will have layer shifts. These shifts do not occur when using cura. I would also like to see a way to create thicker infill walls.


#2

Hi @whosyourdonny1, do these shifts happen always in the same place in a print? Could you share with us a model and the relative gcode with this issue?

Not sure I understand here, do you mean thicker infill lines? If so, this is not possible without increasing also the thickness of the external shell (path width and layer height).
If you mean the thickness of the external shell, this is controlled by the two parameters Minimum shell thickness and Outlines count.


#3


#4

Does this model has this issue? If so could you send us also the gcode?