Multi-color artifact "skipped"

interresting. about 7 layers in to a complex multi-color print on my M3D quad, it skipped an artifact pass and just printed the layer for all the segments in the same color. The next layer went fine… And then later, it did it again.

Version 2.1.0 Experimental, Mac OS X.

Ok, maybe it’s a “feature” :slight_smile: There’s a little option on the Filament preset for “Start from Infill” that is described as only using the artifact where necessary… With Translucent filaments, allowing this would seem to give some weird transitions inside the part…