Line width label chopped off on low resolution screens


#1

I found this out after bumping up my resolution from 720p but the UI chops off the very bottom of some screens on low resolution setups. See attached screenshot, I’ve scrolled all the way to the bottom on the left panel and the bottom two are chopped off, the last thing I can see is the layer height. When bumping it up to 1080p it’s fine but there was no way I could get it to display on lower resolutions


#2

Thanks for the report Greg, we will check this.


#3

Doing more testing today and getting closer with dialing things in, and I also noticed that not all the printing settings save from one session to the next. The filament settings do, but some printing settings don’t. Also, the line width adjustment doesn’t even save if you save your .vox project it always reverts once you exit voxelizer.