Larger nozzle size, dot too small

When using wider nozzle size, and selecting dot, there is a lak of circles.
The dot is configured to do a certain maximum diameter, not an amount of circles.
Wide nozzle like 0.8mm = 2 circles maximum, what is really not sufficient to clean and get ready to print.
Being able to set the amount of cirlcle for the dot could help this situation.
For some case, the dot is not placed at an optimal spot, meaning that the nozzle should never start printing a part crossing the dot position, but passing beside it, this due to some extra material that would be wiped off during that sequence and causing a bad print line.
Using Zmorph VX and Voxelizer experimental.